Pure Water PW90 User Manual (English)

Other manuals for Pure Water PW90

Service Manual31 pages

Programming Guide13 pages

Questions and Answers:

M
Melissa HarrisAug 4, 2025
What to do if my Pure Water Water Filtration System has no water?
- M
  Mark WilkersonAug 4, 2025
  If your Pure Water Water Filtration System isn't dispensing any water, several factors could be at play. First, ensure the system is properly plugged in and the water supply is turned on. Clogged filters can also restrict water flow, so consider replacing the sediment and pre-carbon filters. If you hear no click when pushing the cold button, check fuse F1. Additionally, verify that the fill sensor isn't stuck in the "up" position. Finally, assess whether overuse has exceeded the system's flow rate to the reservoir.
M
Mr. Kevin MartinAug 8, 2025
How to troubleshoot no power in my Pure Water Water Filtration System?
- M
  Micheal LinAug 8, 2025
  If your Pure Water Water Filtration System isn't powering on, start by ensuring it's properly plugged into a functioning outlet. Check the power to the outlet. If the issue persists, inspect fuses F2 and F3 on the circuit board, as a blown fuse could be the culprit.
J
Joanna FloresAug 13, 2025
Why is my Pure Water Water Filtration System not cooling?
- M
  Michelle WoodAug 13, 2025
  If your Pure Water Water Filtration System isn't cooling water, first, make sure the system is plugged in. If it is, the cold control might not be turning on the compressor; in this case, consider replacing the cold control. If these steps don't resolve the issue, refrigerant loss might be the cause, and you should contact a service center.
S
sandranelsonAug 18, 2025
What to do if my Pure Water Water Filtration System has a leak detector alarm?
- J
  John BrownAug 18, 2025
  If you're experiencing a leak detector alarm with your Pure Water Water Filtration System, the issue might stem from an external water source, such as a mopped floor. Inspect the unit and the leak detector pad for any leaks or external water. Dry the leak detector pad, then unplug the system, and plug it back in.
M
Michael PatrickAug 23, 2025
Why is my Pure Water Water Filtration System not dispensing enough water?
- J
  Jasmine LeonardAug 23, 2025
  If your Pure Water Water Filtration System isn't dispensing enough water, it could be due to clogged filters. Try replacing the sediment and pre-carbon filters. Also, consider whether overuse has exceeded the system's flow rate to the reservoir. Check the flow rate to the reservoir; if it's correct, then usage has exceeded the flow.
R
Rebekah CruzAug 28, 2025
What causes reservoir overflows in Pure Water PW90 Water Filtration Systems?
- A
  Ashley RobinsonAug 28, 2025
  If the reservoir in your Pure Water Water Filtration System is overflowing, the fill valve might be stuck open. Check both the fill valve and the fill sensor. Also, ensure the fill sensor slides freely on its stem, as a stuck sensor can also cause the reservoir to overfill.