PURE Jongo S3 Instruction Manual

EN
Add Jongo to your wireless network
The Jongo Setup page should open automatically
on your device. If not, open your internet browser
and enter myjongo in the address bar.
If you want to rename your Jongo, type in the
new name and tap Change name.
Select your wireless network.
Enter your network password if required and
tap Connect.
!
Once you click Connect the light will pulse and
then turn solid green to show that your Jongo
is connected.
If the connection fails, the light will flash
red. Don’t worry, this probably means
you mistyped your Wi‑Fi password.
Just go back to step 2 and try again.
A
B
C
D

PURE Jongo S3 Specifications

General

Speaker type	-
Woofer diameter	88.9 mm
Tweeter diameter	19.05 mm
Number of drivers	4
Number of speakers	1
Audio output channels	1.0 channels
Certification	CE, US FCC/ETL, C-Tick, ETSI EN 300 401
Recommended usage	Mobile phone / Smartphone
Audio formats supported	AAC, MP2, MP3, WMA
Subwoofer included	Yes
Impedance	- Ω
Frequency range	- Hz
RMS rated power	20 W
Product type	Mono portable speaker
Product color	White
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired & Wireless
Power source type	AC, Battery

Weight and Dimensions

Depth	139 mm
Width	131 mm
Height	135 mm
Weight	1000 g