Need help?Do you have a question about the PVI VECOAX ULTRA RF Series and is the answer not in the manual?
Specifies the default IP address for unit access.
Lists supported digital television standards like ATSC, QAM, DVB-T.
Details on configuring Source, Standard, Frequency, Modulation, and channels.
Details on configuring Source, Standard, Frequency, and channels for ATSC.
Details on configuring Source, Standard, Frequency, Modulation, and LCN.
Details on configuring Source, Standard, Frequency, Modulation, and LCN for DVB-C.
Details on configuring Source, Standard, Frequency, and Key ID for ISDBT.
Details on configuring Source, Standard, Frequency, Mode, and LCN for DTMB.
Details on PSIP, PIDs, 1080P conversion, RF attenuation, and mixer mode.
Instructions to change Frequencies, Major/Minor, and Short Name before connecting multiple units.
How to set a static IP address for unit access.
How to access the unit's web interface using its IP address.
How to modify settings for each channel module (MB1-MB8).
How to choose broadcast standards like ATSC, J.83B, DVB-T.
Details on CVCT Mode, 1080P Conversion, RF Attenuation, Mixer Mode, and Fixed EDID.
How to use presets to automatically name and set frequencies for channels.
Details on DHCP, IP Address, Subnet Mask, and Gateway settings.
Steps to upload and apply firmware updates for Mainboard and Modulator.
Solutions for no signal, blinking LED, and power issues.
Information on submitting tickets and phone support hours.
Lists North American Digital QAM cable channels and frequencies.
Lists North American Digital ATSC air channels and frequencies.
Lists Latin American ISDBT channels and frequencies.
To Next Page
General
