Step of install sun-visor housing
Measurements
Push on the headrest with your fingers to make
sure there are no obstructions that would hinder
the installation. Use the paper template to mark
the area to be cut.
Setup work
remove the visor and set it in an uncluttered
work area. Take the appropriate precautions to
ensure that it is not damaged during the installation.
Cut the visor
using an adjustable-depth blade, start
your cut 1/4 inch inside one corner and
cut diagonally across, stopping 1/4 inch in
from the other corner. Repeat the procedure
for the other two corners.
9
To Next Page
Loading...
Need help?
General