Pyle Pro PSPVC4 - Page 2

Thank yor for purchasing PYLE PRO Multi-Speaker Selectors.
It lets you connect up to four (PSPVC4) or six (PSPVC6)
separate pairs of speakers to your stereo receiver/amplifier.
The control certer is especially convenient if you have
speaker sets in different rooms and want to turn them on
and off independently. You can enjoy the convenience
and flexibility of listening to multiple speaker pairs
simultaneously.
The control center lets you use one to four (PSPVCA) or six
(PSPVC6) sets of speakers at a time, and is designed to
operate with a stereo receiver/amplifier that has a
maximum of 100 watts per channel, and with speaker
systems that have a minimum impedance of 8 ohms (see
"Impedance Chart" on page 6)
PREPARATIONS
@Use the PYLE PRO Speaker Selectors only with amplifiers
rated at 100 watts per channel or less.
@Your PYLE PRO Speaker Selector is designed to accept any
size cable up to 14 gauge non-terminated speaker wire. If
you're using non-terminated speaker wire, do not use any
speaker wire that is larger than 14 gauge. The lower the
gauge number, the larger the cable (e.g., 12 gauge is larger
in actual physical size than 14 gauge).
@Do not hook the outputs of one selector into the inputs of
another speaker selector together.
@Before you connect the AC power source, make sure you
set ALL speakers ON/OFF to OFF
@Left and right "commons" are isolated to work with all
types of amplifiers
@Auto transformer impedance protection.