www.PyleUSA.com
6
EQ Controls
Before you install batteries or plug your guitar into an amplier, make sure that all volume knobs or are at zero.
4. BASS: Controls the amount of bass frequency in the signal.
All the way left = no bass, all the way right = Lots of bass. Everything else in between!
5. MIDDLE: Controls the amount of mid frequencies in the signal.
6. TREB: Controls the amount of treble frequencies in the signal.
7. PRESSENCE: Provides a little extra avor to your signal- adjust to taste.
8. V (Volume): Controls your volume output.
8. LOW BATTERY: Turns ON when your battery is low.
*Be sure to unplug your cable when the instrument is not in use, as the battery will drain as long as a cable is plugged
into the instrument.
1. Plug in: Connect to an amplier with a instrument cable.
The batt light will ash once quickly to indicate it has switched on.
2. Digital Tuner: Press the tuner button and the guitar is muted and
chromatic tuning is engaged, key clearly displayed on the LED
screen. You may tune any string you like, and the tuner will pick
up the signal and indicate if you are sharp or at.
3. Phase: When the phase button is activated the guitar tone will
produce more warmer sounds, e.g. more bass tones will come
through, when switched o, the phase can cut bass response
often helping avoid feedback in gig situations.
To Next Page
Loading...
Need help?
General
