Need help?Do you have a question about the Pyle PLAM1200 and is the answer not in the manual?
General| Brand | Pyle |
|---|---|
| Model | PLAM1200 |
| Category | Car Amplifier |
| Language | English |
Mount amplifier away from receiver for noise reduction. Consider under-seat, trunk, or hatch locations.
Ensure adequate airflow around cooling fins, avoid dust, moisture, and direct sunlight for heat dissipation.
Securely mount to a strong, solid surface that can withstand stress from sudden stops or accidents.
Avoid continuous exposure to sound levels over 100dB to prevent permanent hearing loss.
Disconnect the car battery before any connections to prevent electrical system damage.
Use heavy gauge copper cable (min 10mm²) for +12V, with an in-line fuse near the battery (max 50mm).
Connect the ground terminal directly to the battery (-) or chassis, ensuring clean metal contact.
Connect the amplifier's REM terminal to the head unit's remote output or an external switch.
Ensure all power cable connections are tight to prevent malfunctions, interference, or distortion.
Protects the amplifier and vehicle electrical system against short circuits.
Connect right and left speaker wires to corresponding terminals, ensuring correct polarity.
To Next Page
