• The display UPPER LlMIT (upper limit
of
the speed)
appears, set with the SELECTION button
(1
.0 to 40.0 kmlh
possible). confirm with the A button.
• Display
CAli.
FOR RUNNING (calibration for runn
in
g)
appears, you can choose between YES or NO with the
C button. Choose YES and confirm with the
A button.
• Display SET CA
ll
DISTANCE appears, choose with the
C button (0.1 to 1.0
km
possible), confirm with the A button.
• Display PRESS SET TO START appears. start with
A button. Now run the chosen distance (the display
PRESS TO END appears) and press the A button
afterwards.
-
\
-
-
HOLD
TO
SET
.-
-
\
CALI
FOR
RUNNING?
YES
1:
PRESS
TO
END
S: C
/.ffi
\
LOWER
LHlIT
•
OD
K
MH
~fT
CALi
DISTANCE
IlI
KM
-
...
UPPER
LIMIT
•
IOD
KMH/
-
/.ffi \
1:
PRESS
SET
TO
•
START
_
• Display CALlBR. OK! and SAVE appears The calibration
was correct and was saved.
• The watch now changes to the display CAU FOR WALK
IN
G
(calibration for walking).
It is important that you also perform the calibration for
walking, as described
in
the following section:
• You can choose between YES and NO with the C
button. Choose YES and confirm with the A
bullon.
• Display SET
CAll
DISTANCE appears, choose with the
C bullon
(0
.1 to 1.0 km possible), confirm with
the A button.
• Display PRESS SET TO START appears, start with
A button.
Now walk the chosen distance (the display PRESS TO END
appears) and press the A button afterwards.
• Display
CAli.
OK! and SAVE appears The calibration
was correct and was saved.
• Finally press the 0 button, the watch changes to the
initial position (display of current speed and lower and upper
limits for the speed).
Ca
libr
at
io
n
not
Successful.
In case the calibration was not successful. the display CALI
FAILED appears. Alter a few seconds the display
CAll
FOR
RUNNING or WALKING appears again and you can start a
new calibration.
To Next Page
Loading...