Before using your new Speaker System Please review the
following instructions, for the safety and investment.
INSTRUCTIONS
Before connecting the speaker, make sure the system is off and the controls on the minimum level. On the
contrary the system could damage
1.Plug the power cable to the AC outlet and to the system and the speaker
2.Plug the microphone in the “MIC” input
3.Connect (CD, DECK, MP3, DVD, etc) on “LINE IN” input
4.Turn on the systems. A green LED will light up to indicate the speaker is on
5.Set the volume on the low level on the MIC and the LINE IN input
6.Increase the master volume (place on the right side of the LINE OUT *connector)
7.Set TREBLE and BASS controls to equalize the sound
8.A red LED will light up when the system detects overload power. You will must decrease the volume.
CAUTIONS
Do not place the microphone against the speaker, it can cause feedback echo and it will damage the system
EXTRA FUNCTIONS
6.3 And XLR connectors marker as LINE OUT can handle an amplifier or even another powered speaker
cabinet. On the bottom of the speaker there is a hole to place a stand.
To Next Page
Loading...
Need help?
General
