Pyronix V2 GSM - User Menu Prompts and Voice Messages; User Menu Voice Prompt 1; User Menu Voice Prompt 2

V2 GSM Installation Manual
Pyronix Ltd Page: 33
CHAPTER 6: USER MENU PROMPTS
The V2 GSM is pre-programmed with default prompts for the user menu (this is when a
user will receive a phone call from the V2 GSM or dials in directly to the V2 GSM – if
‘remote control’ is enabled). Each prompt can be changed by a ‘hidden’ menu that is only
accessible via the function numbers (not via scrolling through the engineer menu)
IMPORTANT: IF NEW MESSAGES ARE RECORDED, THE DEFAULT
RECORDINGS WILL BE ERASED PERMANENTLY.
6.1 USER MENU PROMPTS
6.1.1 Play/Record Voice Prompt: 1 [111]
“Enter your user code.”
To change the above message, enter
‘111’ press t
1
= To play a message
4 = To record
9 = To delete
The message can only be 5 seconds
6.1.2 Play/Record Voice Prompt: 2 [112]
“Enter your command number or press nine for help.”
To change the above message, enter
‘112’
Press t
1
= To play a message
4 = To record
9 = To delete
The message can only be 5 seconds