15
© 2005 directed electronics, inc. all rights reserved
bypassed, the 60-minute bypass period will start over. This
ensures that a sensor that continually triggers will remain
bypassed.
Doors are covered by NPC differently; if the alarm is triggered
by an open door for three full cycles, the doors will be bypassed
until the trigger ceases.
NPC is programmable. See
Programming Options
section of this
guide.
note: Arming and disarming the system does not reset this
function! The only ways to reset a bypassed zone are for it
to not trigger for 60 minutes, or to turn on the ignition. If
testing your system, it is important to remember that the
NPC programming can cause zones to be bypassed and
appear to stop working. If five chirps are heard when dis-
arming, NPC has been engaged. If you wish to clear the
NPC memory, turn the ignition key on.
To Next Page
Loading...
Need help?
General
