© 2005 Directed Electronics—all rights reserved
2255
pplluugg--iinn LLEEDD aanndd vvaalleett//pprrooggrraamm sswwiittcchh
These plug into the module. The status LED plugs into the small two-pin socket, while the Valet/Program switch
should be plugged into the larger blue two-pin connector. The status LED fits in a
9
/
32-inch hole.
NNOOTTEE::
Never use a BLUE LED in combination with a RED LED.
SSttaattuuss LLEEDD VVaalleett//PPrrooggrraamm SSwwiittcchh
pprrooggrraammmmeerr iinntteerrffaaccee,, 33--ppiinn ppoorrtt
The black 3-pin port is provided for programming of the unit. The unit can also be programmed using the
Bitwriter. When using the Bitwriter, it is possible to configure any and all of the programmable functions as well
as lock the Transmitter/Receiver and System Features Learn Routines so that unauthorized users cannot change
the configuration or program transmitters to the unit.
When the learn routines have previously been programmed using the Bitwriter, they may have been locked.
Before proceeding with reprogramming the learn routines, they must be unlocked with the Bitwriter - this
cannot be done manually with the Valet switch.
To Next Page
Loading...
