28
© 2002 directed electronics, inc.
If the system has entered the triggered sequence (siren has begun
chirping), pressing the disarm button of the transmitter will not
disarm VRS
®
. To disarm the VRS
®
during a VRS
®
trigger
sequence:
1. Turn the ignition on.
2. Press the Valet switch the pre-
programmed number of times to
disarm the VRS system.
gglloossssaarryy ooff tteerrmmss
Control Unit:
The "brain" of your system. Usually hidden under
the dash area of the vehicle. It houses the microprocessor which
monitors your vehicle and controls all of the system's
functions.
Fail Safe Starter Kill
: An automatic switch controlled by the secu-
rity system which prevents the vehicle’s starter from cranking
whenever the system is armed. The vehicle is never prevented
from cranking when the system is disarmed, in Valet mode, or
should the starter interrupt switch itself fail. Your system is ready
for this feature, however installation may require additional
labor.
note: If the VRS® system has begun its chirping
sequence, the ignition must be turned off, then on to dis-
arm. If you are driving the vehicle at the time, pull to a
safe place away from traffic and follow the triggered
sequence disarm procedure.
To Next Page
Loading...
Need help?
General
