Q-See QCN7001B - Connect to the Router; Powering up the NVR & Cameras

8
B. Connect the other end of the cable to an open port
on your router (not included). You will hear a click
when the cable is properly connected.
Step 5: Connect to the Router
A. Plug the included Network (Ethernet) cable into the
Network (LAN) port on the back of the NVR.
Step 6: Powering Up the NVR &
Cameras
A. Plug the NVR power supply cable into the DC Port
on the back of the NVR.
B. Plug the NVR power supply cable or power adapter
into a surge protector (not included).