● HIGH WINDS:
lt is possible for the Trampoline to be blown about by high wind. lf you
anticipate high winds, the Trampoline must be moved to a sheltered
location, or be disassembled.
ASSEMBLY WARNINGS
● The minimum overhead clearance required is 26 feet (8 meters). Ensure
that no hazards or obstructions are near the trampoline such as tree
branches, swing sets, swimming pools, electrical power wires, walls,
fences, roof overhangs etc.
● Please be aware of the following when selecting a place for your
trampoline:
● Trampoline must be placed on a level surface.
● All obst
ructions from overhead, underneath or around the trampoline
must be removed.
● Do not use this trampoline indoors.
● Do not use this trampoline on any slippery/smooth floor surface, uneven
or sloping ground surface.
● Do not place the trampoline on hard surfaces, such as asphalt, stone,
concrete etc, as this can damage the frame.
● You increase the risk of serious injury and/or death if you do not follow
these guidelines.
● The area must be well lit.
● When you are ready to start, make sure that you have the correct tools at
hand, and adequate space for assembly.
● Please refer to the table for p
art descriptions and numbers. The
assembly instruction uses these descriptions and numbers as reference.
Make sure you have all parts listed. If you are missing any parts, please
contact our customer service.
-6-
To Next Page
Loading...