QiCYCLE Mini - Page 13

11
Troubleshooting
Problem Solution
Slowinflationspeed
1.Checkwhetherthe aircompressor'sbatterylevelis
sufficient.
2.Checkwhethertheairhoseisleaking.
3.Checkwhetherbothendsoftheairhosearesecurely
connected.
4.Checkwhethertheitemthatisbeinginflatedisleaking.
Aircompressorturnsonbut
doesnotinflate
1.Checkwhethertheaircompressor'sbatterylevelis
sufficient.
2.Checkifthecurrenttirepressureishigherthanthe
presetvalue.
Aircompressorinflates
normallybutthedisplayed
pressureiszero
Productssuchasballoonswithlowinflatablepressureare
notwithintherangeofthisproduct.
Aircompressorwasalready
turnedoffafterconnectingthe
airhosetoavalve
PressandholdtheON/OFFbuttontoturnon theinflater
again.
Airleaksoutwhenconnecting
theairhose
Tightenthevalve.
Thecolorofthebattery
indicatorintheinflatedstate
isinconsistentwiththatinthe
standbystate.
Thereisasignificantvoltagedropwhenthelithiumbattery
isbeingdischarged,whichleadstocolorinconsistencies
betweentheindicatorsintheinflatedstateandthestandby
state.Thisisnotconsideredafault.
Cannotbeturnedon Makesurethatthebatteryissufficientlycharged.
Cannotinflateordetectair
pressure
1.Makesurethatyouareusingthecorrectvalveconnector.
2.WhenusingthePrestavalveadapter,makesurethatthe
screwsofthetirevalvecoreareunscrewed.
3.WhenusingtheSchradervalveadapter,makesurethat
thetirevalvecoreiscleanandfreeofforeignparticlessuch
asdirt.
ErrorcodesE1,E2
Ifthetemperatureexceedstherange,letthedevicecoolat
roomtemperatureforonehourbeforeuse.
ErrorcodeE6
Whentheair pressureexceedstherange,unscrewthe
valvetocheckifthepressureisrestored.Iftheerrorcode
disappears,checkifthepressureoftheinflationtarget
exceedstherange.