Qqest Software Systems IQ 300 - Ethernet; Set IP Address

Qqest Software Systems, Inc. Using the IQ 300 Time Clock
3/24/2008 4 of 7
When you select this option, you receive the following prompt:
PLEASE CONFIRM:
DELETE ALL DATA?
NO YES
The <NO> and <YES> buttons are two gray rectangular buttons located
above the numeric keypad on the clock face. The button on the left is the
<NO> button and the one on the right is the <YES> button. Press the
appropriate response. When you have made a selection, you will be
returned to the Memory menu.
Set to Defaults
This option resets the clock ID, Password and all custom-definable ranges
to the default settings. When you select this option, you receive the
following prompt:
PLEASE CONFIRM:
SETTING DEFAULTS
NO YES
Press the appropriate response. When you have made a selection, you will
be returned to the Memory menu.
Set Clock ID
When you select this option, you rec eive the following prompt:
SET NEW CLOCK ID
CURRENTLY: [XXXXX]
CLOCK ID:
The Currently field shows the current clock ID. By default, this is
³00001.´ To change the clock ID, type in the new ID and press
<ENTER>.
Ethernet
This menu contains the clock¶s ethe rnet settings. This menu has four options:
1. SET IP ADDRESS
2. SET SUBNET MASK
3. SET GATEWAY
4. SHOW SETTINGS
Set IP Address
When you select this option, you receive the following prompt:
SET NEW IP ADDRESS:
CURRENTLY:
ENTER NEW IP:
The Currently fie ld shows the current IP Address. To change the clock IP
address, type in the new address and press <ENTER>.