QSC touchmix-30 pro Windows Driver Manual

TouchMix-30 Pro Windows Driver
Quick Start Guide
1
Introduction
The TouchMix-30 Pro Windows Driver creates an interface between a TouchMix-30 Pro mixer and a computer running the Windows 7, Windows 8, Windows 8.1, or
Windows 10 operating system (recommended). The program supports up to 32 × 32 channels of digital audio between the mixer and the computer.
Installation
1. Extract the compressed folder to a new location.
2. Open the new uncompressed folder and run
Setup .
3. The Windows operating system will ask if you want to allow the program to make
changes to your device. Click
Yes .
4. The
Setup Welcome window will appear. Click Next > to continue.
Connection
1. Use a Type B USB cable to connect the mixer's USB DAW port to a USB port on your
computer.
5. Accept the default location for the driver folder or browse to another location. Click
Install .
6. The installer will copy the files to the selected location. When it is done it will present a
message that the driver has been installed on your computer. Click
Finish .

QSC touchmix-30 pro Specifications

General

Type	Digital Mixer
Channels	32
USB Interface	Yes
Effects Processors	4
Wireless Control	Yes
Phantom Power	Yes
Outputs - Aux	6
EQ Bands	4-band parametric
Computer Connectivity	USB
A/D Resolution	24-bit
Sampling Rate	48kHz
Bit Depth	24-bit
Wireless Control Platforms	iOS, Android
Aux Outputs	6
Main Outputs	2
Touchscreen	Yes
Headphones	1
Effects	Reverb, Delay, Chorus
USB	2.0
Power Source	AC
Display	10-inch Touchscreen
Stereo Line Inputs	2 stereo pairs
Inputs - Line	2 stereo pairs