Need help?Do you have a question about the QSI quantum and is the answer not in the manual?
Describes how to start and run the locomotive forward using analog controls.
Explains the procedure for reversing the locomotive's direction.
Covers specific startup procedures for Quantum-equipped locomotives in analog mode.
Explains how inertia affects locomotive response and how to adjust it.
Explains the locomotive's behavior and available functions when in Neutral state.
Details how to change direction while keeping sounds active.
Introduces the QARC controller and its capabilities for analog operation.
Identifies keys on the Quantum Engineer controller for sound and programming.
Explains how to enter and navigate programming mode using the controller.
Provides step-by-step instructions to enter analog programming mode.
Details how to select and modify program options.
Explains how to navigate options and exit programming.
Illustrates setting the locomotive's throttle control mode (RTC/STC).
Guides setting the voltage at which the locomotive leaves Neutral.
Illustrates setting the voltage for full throttle application.
Outlines initial steps for operating the locomotive with a DCC system.
Lists DCC function keys and their operations in Forward/Reverse and Neutral.
Explains how to use F7 to apply air brakes for quicker deceleration.
Introduces the three stages of locomotive shutdown controlled by F9.
Details the first stage of locomotive shutdown.
Details the second stage of locomotive shutdown.
Details the final stage of locomotive shutdown.
Describes how to start the locomotive from various shutdown stages.
To Next Page
General