Quadra-Fire 1900 - Dimensions; Pedestal Model; Leg Model; Top Heat Shield Installation

Page 4
DIMENSIONS
FIGURE 2
FIGURE 1
LEG MODEL
PEDESTAL MODEL
22 1/2" (572mm)
16 1/4" (413mm)
19 5/16" (491mm)
26 3/4" (680mm)
11 5/16" (287mm)
29 3/4" (756mm)
2" (51mm)
1 7/8" (48mm)
19 5/16" (491mm)
22 1/2" (572mm)
16 3/4" (426mm)
28 7/16" (722mm)
10" (254mm)
5 3/16" (81mm)
23 1/8" (587mm)
26 7/8" (683mm)
26 3/4" (680mm)
13 3/8" (340mm)
2" (51mm)
Page 25
1. Unscrew and remove the rear heat deflector.
2. Attach the two S clips to the upper edge of the outer wall of the stove.
3. Set top heat shield on stove and push down into S clips
4. Install chimney pipe through hole in top heat shield.
NOTE: SEE PAGE 5 FOR REDUCED CLEARANCES WITH THE STANDARD TOP SHIELD.
TOP HEAT SHIELD INSTALLATION
Rear heat deflector
S clips
Chimney pipe
Trim ring
Top shield
Outer wall
Top heat shield