26
Tip the machine slightly towards the oil ller pipe and reach under the deck.
Hold the blade and unscrew the blade bolt counterclockwise using a spanner wrench.
Remove the washer and the blade.
Inspect the blade adaptor for any signs of damage.
Fit a new blade, locate the blade on the two studs on the blade ange and then replace the
washer and bolts.
Check the washer is still slightly domed to keep the pressure on the bolt to stop it
unwinding, keeping the blade rmly secure. Then replace the washer (right way around!)
and bolts.
Make sure the blade is correctly located, and then rmly tighten the bolt. Do not over
tighten. The up turn of the blade must project into the motor compartment.
NOTE: If you are unsure about performing this operation, call our helpline or go to an
authorised dealer to change the blade for you.
List of consumable parts:
QC12YC Spark plug 932217 Blade bolt
1813907 Collection grass bag 466018 Fixing knob
460206G Blade
Parts can be ordered via www.gardenservicecentre.co.uk.
To Next Page
Loading...
