Quality SUPERFLO 2 - Troubleshooting Motor Issues; Motor humming but not turning; Motor tripping earth leakage; Motor overheating

6
QUALITY SERIES 2 PUMPS | OPERATION, INSTALLATION & WARRANTY INFORMATION
3. Motor humming but not turning:
IMPORTANT: SWITCH POWER OFF
- Possibility of blown capacitor or worn bearings, call a qualied person/s
- Possible debris in the impeller and/or diffuser causing motor lock
4. Motor tripping earth leakage:
- Water inside motor or burned out
- Damaged cables
5. Motor overheating:
- Poor ventilation, fan installed too close to wall (minimum of 5cm
unobstructed)
- Wrong impeller tted
- Wrong capacitor tted
- Mechanical overload from poor quality bearings or impeller, or diffuser
blocked with grass or other solids
- Check Ampère (amp) reading against name plate specs
6. Pump not priming properly:
- Installed too high above water level of pool (maximum of 300mm above
weir)
- Sucking air
- If pump is installed too high above the pool level, t a spring loaded non return
valve into suction line coming up from underground before entering pump
SPARE PARTS
Please refer to the Quality Pool and Spa website,
www.qualitypoolandspa.co.za for a detailed spare parts breakdown.
DECLARATION OF CONFORMITY
This product range conforms to the relevant Compulsory Specications.
WARRANTY
The product must be installed, used and maintained with the care described in
this instruction manual. Any damage caused by non-observation of the safety,
operating and maintenance instructions is the sole responsibility of the user.
This applies in particular to:
- Incorrect electrical connection (voltage)
- Inadequately dimensioned power cable
- Improper use of the product
- Product modications not approved by Fluidra