Quality SWIMFLO 2 - Applications and Sizing; Pump Installation and Instructions

3
QUALITY SERIES 2 PUMPS | OPERATION, INSTALLATION & WARRANTY INFORMATION
knowledge, unless they are under supervision or instruction concerning use
of the product by a person responsible for their safety.
- Children should be supervised, at all times to ensure they do not play with or
near the product.
- Only a qualied person/s, should perform repairs and/or maintenance
work on the pump and motor.
-
-
APPLICATIONS
- Carefully select the recommended pump to suit your pool.
See below the recommended pump and pool sizing chart.
- The pump is self-priming and may be installed to a maximum height
of 300mm above the weir level.
- If you choose to install your pump below the weir level, be sure to connect
a shut-off valve on your suction pipe between the pool weir/skimmer and
the pump. This will prevent your pump motor from being ooded and/or
damaged when you open the pump lid to clean the leaf basket.
- The pump is intended for residential pool and spa use with a
maximum water temperature of 40°C.
PUMP INSTALLATION AND INSTRUCTIONS
- Position the pump on a rm, at, level surface that is not exposed to ooding.
- A minimum of 50mm PVC pipe to be used on the suction and return lines.
- If solvent weld is used in the installation, allow 24 hours to dry, before running
the pump for the rst time.
- A certied electrician must do the electrical connection
in accordance with SANS 10142:
- The voltage of the mains supply to the pool distribution board must
correspond to the indicated voltage of the product.
PUMPS SIZE FILTER SIZE POOL VOLUME
0.6kW 2 bag sand lter 30 000 Litres
0.75kW
3 bag sand lter 60 000 Litres
1.1kW
4 bag sand lter 90 000 Litres