1919 EN
WARRANTY, SAFETY AND INSTALLATION
installed. This should be done by two (2) people, so that the base of
the machine is exposed, allowing it to be worked on easily.
Once the fryer unit is on the work surface, insert the fryer, and lower
the extractor dock over the case so that fumes do not escape while
frying.
Connect the machine to a single phase 20 Amp plug so that you can
turn it on and insert 5.5 litres of oil.
You can also see this whole procedure in the following video by
scanning the following QR code “Unpacking and setting-up the
machine”.
EXPLANATORY VIDEO
This QR code takes you to video about
setting up the fryer.
To Next Page
Loading...