PCI Configuration
*1: Disabled/Enable with PXE/Enable without PXE
*2: Slow-Mode/Full-Speed
*3: Auto/4.800GT/5.866GT/6.400GT
*4: Disabled/Enabled
*5: Disabled/Enabled
*6: Auto/128 Bytes/256 Bytes
NOTE: If “iSCSI Remote Boot” be enabled, then both NIC1 and NIC2 will not be displayed.
Control Group User Access Level
Maximum Payload Size Access Level 2
iSCSI Remote Boot Access Level 1
NIC1 – KAWELA Access Level 1
NIC2 - KAWELA Access Level 1
PCI-E SLOT Option ROM Access Level 2
PCI-E Connector Option ROM Access Level 2
QPI Links Speed Access Level 1
QPI Frequency Access Level 1
QPI L0s and L1 Access Level 1
Crystal Beach / DMA Access Level 1
Intel VT-d Access Level 1
SR-IOV Supported Access Level 1
Active State Power Management Access Level 2
ME Support Access Level 1
Chapter 3 — BIOS
43
Advanced
BIOS Setup Utility
pppppppOptionspppppp
Disabled
Enable with PXE
Enabled without PXE
iSCSI Remote Boot.
← Select Screen
↑↓ Select Item
-+ Change Option
F1 General Help
F10 Save and Exit
ESC Exit
PCI Configuration
----------------------------------------------------
Maximum Payload Size [Auto]*6
iSCSI Remote Boot [Disabled] *4
NIC1 - KAWELA [Enable with PXE]*1
NIC2 - KAWELA [Enable with PXE]*1
PCI-E SLOT Option Rom [Enabled] *5
PCI-E Connector Option Rom [Enabled] *5
NIC1 Mac Address [00-23-8B-64-8E-EC-CD]
NIC2 Mac Address [00-23-8B-64-8E-EC-CE]
Current QPI Frequency 6.400GT
QPI Links Speed [Full-Speed]*2
QPI Frequency [Auto]*3
QPI L0s and L1 [Enabled] *5
Crystal Beach/DMA [Disabled]*4
Intel VT-d [Disabled]*4
SR-IOV Supported [Disabled]*4
Active State Power-Management [Disabled]*4
ME Support [Enabled] *5
v02.66
To Next Page
Loading...
