24
14.3 Wireless Auto Fill
Wireless Auto Fill mode has several useful features. It can add light ratio
capability to non-TTL cameras. With digital cameras Auto Fill mode can
decrease the delay between shutter release and image capture, compared
to the camera system’s TTL control. And, Auto Fill with Qflash sensor con-
trol lets the photographer fine tune flash exposure for her/his particular
needs without being locked into camera TTL exposure.
Set the camera modes: Manual, aperture priority, or shutter priority.
Program mode may be selected, although the camera will make decisions
that reduce your control of the shots.
14.3.1 A local, on-camera flash is optional.
To change the linked value Press the Set G button once. Use the
Up J/Down L buttons to select the desired option. To change the Fill
value use the Fill dial located on top of the QTTL adapter.
14.3.2 Set up the Mode of the Remote Qflash(s)
Connect a FreeXWire receiver to the
remote Qflash(s). FreeXWire model
FW7Q connects directly to Qflash; models
FW8R or FW10w require an FW31 cable
for connection.
To set a Remote flash to the Local
group: Press Mode I, then “Linked
to Local”. This Remote Qflash
exposure will be the same as the
Local, on-camera Qflash.
If you are not using a Local on-
camera Qflash: Press Mode I,
then Up J/Down L until the display
shows “Wireless Auto Fill”.
To Next Page
Loading...
Need help?
General
