BES X installation manual System first start-up
P/N: 400288005; Rev: L, 09/21 97
12 System first start-up
The 4HD/5HD-CPU unit is addressed from the Conqueror X LANE SETUP section. Insert the serial number of
each 4HD/5HD-CPU into the Conqueror X LANE SETUP section (serial numbers can be read on the lane
monitors during the boot-up of the lanes).
Once the hardware of the BES X system has been correctly installed, as described above in this manual, follow
these steps in order to configure Conqueror X with the new scoring system.
For a new installation follow this procedure:
Turn on the 4HD/5HD-HUB units, plugging the power cord to the power source.
The following image will appear on the monitor,
please take note of the SERIAL NUMBER (S/N).
On a front desk computer, navigate through the Conqueror X main menu and select:
SETUP / Lane Setup / Lane Setup.
In the Lane Setup screen, select the lane where the serial number of the 4HD/5HD-CPU
unit must be set up and click on Modify.
Insert the serial number of the 4HD/5HD-CPU. Set also the number of the monitors, the
pinsetter interface, the keyboard type and all other desired options (refer to the “Lane
setup parameters screen brief description” par. for a brief description of each
parameter); click on OK when finished.
Repeat the procedure from step 4 for each pair of installed lanes.
Click on Save on the LANE SETUP screen and Conqueror X will restart.
Each lane will reboot within five minutes.
To Next Page
Loading...