• SuperTouch console with English language en-us_TOUCH: Chinese touch screen,. Eastern Europe
touch screen, English touch screen, Korean touch screen, Vietnamese touch screen.
• Japanese touch screen (ja_TOUCH): SuperTouch console with Japanese language.
• German touch screen (de-de_TOUCH): SuperTouch console with German language.
• Russian touch screen (ru_TOUCH): SuperTouch console with Russian language.
Intercom: enables the intercom on this lane. NOTE: Check (enable) this option ONLY if a Q-COM system has
been purchased and installed.
Lane monitors: specify the model of the overhead monitors connected to the serial control cable or IR control
cable to the 4HD/5HD-CPU. Select QUBICA STANDARD if the monitor is not supported.
Monitors on lanes: specify how many overhead monitors (“UP” monitors) and how many touch screen
monitors (“DOWN” monitors) are present on the pair of lanes:
• 2 UP: two overhead monitors and no SuperTouch console.
• 2 UP – 1 DOWN: two overhead monitors and one SuperTouch console per pair of lanes.
• 2 UP – 2 DOWN: two overhead monitors and one SuperTouch console per lane.
• 3 UP: three overhead monitors and no SuperTouch console.
• 3 UP – 1 DOWN: three overhead monitors and one SuperTouch console per pair of lanes.
• 3 UP – 2 DOWN: three overhead monitors and one SuperTouch console per lane.
• 2 DOWN: no overhead monitors present and one SuperTouch console per lane.
Redemption: enables the Redemption.
Pinspotter type: specify the pinspotter model and the pinspotter interface installed on this lane.
Foul input check, No cycle practice, Full set practice: these checkboxes enables the options in the Lane
Options menu.
Total frames, Total minutes: these are counters for the lane usage.
Bumpers, Smoking area, Access facilities: specific information for the reservation module.
Aux and Sweep: TCS setup parameter.
HDMI Settings button:
This button must be used in two cases when:
1. the monitor connected to the 4HD/5HD-CPU will not show any image, and “NOT SUPPORTED”, “NOT
AVAILABLE” or a similar message is shown on the monitor. This occurs as not all monitors support all
of the HDMI video resolutions. In order to fix this issue, you can use the EDID mode option explained
below.
To Next Page
Loading...