BES X installation manual System first start-up
P/N: 400288005; Rev: L, 09/21 103
2. the monitor connected to the 4HD/5HD-CPU will show an image, but it does not properly fit on the
screen and there is no option to adjust the image shown on the monitor. In order to fix this issue,
you can use the “View size” option explained below.
Once you click on the HDMI Settings button you will see the following window where you have two options:
Edid mode: this menu will give you the possibility to select
four different modes for the HDMI video output, these are:
01 - HD 50 Hz;
02 - HD 60 Hz;
03 - HD Scaled 50 Hz;
04 - HD Scaled 60 Hz.
By default, the mode is set to 01 - HD 50Hz, but as explained
above in the case that the monitor shows you the message
“not supported”, you can try to change it to another mode,
save it and restart the pair of lanes to see if you get the
image displayed.
THE SUGGESTED RESOLUTIONS ARE 01 - HD 50Hz or 02 -
HD 60Hz.
Every time you make a change you must restart the lanes to apply the change. You can restart the lane from
the upload to lanes screen by clicking on Reset.
View size: This option gives you the possibility to resize the image in the case where the monitor does not
have any auto resize option (that we require for compliance with our system, normally called “just scan” or
“screen fit” but this name may change with different monitor brands). The view size value must be in a range
from 0 to 200. Click on Apply to apply the changes in real time after any changes. This functionality does not
require a restart of the lanes.
To Next Page
Loading...