BES X installation manual System boot-up sequence
P/N: 400288005; Rev: L, 09/21 107
▪ ONLY WITH 4HD-HUB REV.2: Test TbQir on D2: 1 infrared receiver is connected to the D2 port of the
4HD-HUB Rev.2 unit.
▪ ONLY WITH 4HD-HUB REV.2: Test TbQir on D1 & on D2: 2 infrared receivers are connected to the D1
and to the D2 port of the 4HD-HUB Rev.2 unit.
4. Monitor video output:
▪ UL: Upper Left (odd lane).
▪ UR: Upper Right (even lane).
5. If the device works properly, the result of its test will be “Okay”, alternatively an error code is displayed,
and the entire boot of the 4HD/5HD-CPU will stop.
▪ L-COM: test of the entire L-COM line integrity.
▪ Camera: test of the connection between the camera and the camera board.
▪ Q-Foul: Q-Foul (or Radaray on AMF XL/XLi series pinspotters) device is connected to the system.
▪ M-I/O: an EDC unit is connected to the L-COM.
6. The background color of this part of the screen indicates if the 4HD/5HD-CPU unit is able to communicate
with the front desk. The background color can be as follows:
▪ Red: The 4HD/5HD-CPU unit does not have a valid IP address, so it is not able to communicate with
the front desk.
▪ Blue: The 4HD/5HD-CPU unit is able to communicate with the front desk.
7. Additional information regarding the 4HD/5HD-CPU software is displayed in this area:
▪ First row: IP address assigned to the 4HD/5HD-CPU unit.
▪ Second row: Serial number of the 4HD/5HD-CPU unit.
▪ Third row: Version of the scoring software.
▪ Fourth row:
• GVer: Grids version.
• Sver: Spare finder version
• TVer: TNC (animations) versions
13.2 Error list
All these errors are displayed on the affected pair of lanes icons as BOOT XXX (where “XXX” indicate the error
number).
To Next Page
Loading...