BES X installation manual How to
P/N: 400288005; Rev: L, 09/21 111
14 How to
14.1 How to turn on/off the pair of lanes
QubicaAMF recommends turning off the scoring system every night to save power.
14.1.1 Turning ON the system.
This is the procedure to follow in order to turn on the system in the morning for BES X Scoring systems:
• Turn on Front Desk 1;
If a separate server is present it should already be ON;
• Turn on overhead monitors;
• Wait until the Front Desk1 boots-up completely (note that in the case of Conqueror X backups, you
should wait until the backup process has been completed) then turn on the 4HD/5HD-HUB units;
• Turn on all other Conqueror X Front Desks / Terminals.
• In the case of LCD monitors controlled from the Front Desk (AccuVision, etc.) turn on the monitors
from the Special Functions on the Front Desk.
14.1.2 Turning OFF the system.
This is the procedure to follow in order to turn off the system at night for BES X Scoring systems:
• In the case of LCD monitors controlled from the Front Desk (AccuVision, etc.) turn off the monitors
from the Special Functions on the Front Desk.
• Close the Conqueror X application on all the terminals;
• Turn off Front Desk1;
NOTE: if a separate server is present, or in the case you purchase a web-booking system the
Conqueror X server computer should be always kept on;
• Turn off all the other Front Desks;
• Turn off the 4HD/5HD-HUB units from the Electronic sub-panel breakers;
• Turn off Overhead Monitors from the Electronic sub-panel breakers.
14.2 How to boot the BES X system in emergency (in the case of a Conqueror X
server PC crash)
If the Conqueror X server is down and there are either no other Conqueror X licensed computers available
(i.e. if it is not possible to convert a Front Desk 2, 3, etc., or convert the Back Office into a Conqueror X server)
it is possible to reboot lanes in emergency.
To boot the BES X system in emergency:
• Keep the Conqueror X server turned off or disconnect the network cable from the Scoring NET
network card (the secondary network card).
• Reset (turn off and on) all the 4HD/5HD-HUB units by unplugging the power units;
• The 4HD/5HD-CPU units boot without IP address, displaying a RED background on the lane monitors.
In emergency the lanes can be opened using either the lane consoles keypads (EasyKey) or LCD touch screens
(SuperTouch).
To Next Page
Loading...