How to BES X installation manual
118 P/N: 400288005; Rev: L, 09/21
Now check how the cable cover fits in its housing. If the 288100019:
• FITS perfectly in its housing: the cover does NOT need any adjustment; tighten the screws and mount
the “V-Support back” previously removed from the console stand.
• Does NOT fit into its housing and there are two plastic teeth preventing the cover from easily closing
the compartment: the cable cover MUST be adjusted.
14.7.2 How to adjust the 288100019 cable cover
Insert the two (2) cable cover screws (P/N: 289X06238) in the holes present on the cable cover and block
them using the two (2) supplied O-Rings (P/N: 289X06142).
Locate the two plastic teeth on the internal side of the 289X15140 cover.
Remove both teeth from the cover using a wire-cutter or by bending them upwards.
Now the cable cover will fit perfectly into its housing and will easily close the compartment.
Put the cable cover in position, tighten the cable cover screws and mount the “V-Support back” that was
previously removed.
To Next Page
Loading...