QubicaAMF 400288005 - Conqueror Pro Procedures; Upload Programs or Reinitialize System

BES X Dual Mode BES X installation manual
122 P/N: 400288005; Rev: L, 09/21
T.90.250 – Typical layout with 4HD-HUB and 4HD-2COM units for Highway66
4 -HD HUB
UNIT
4 -2HD COM
UNIT
TMS
CHASSIS
T.90.251 – 4HD-HUB and 4HD-2COM units connections
BACKEND MOTOR
DIAG
E-STOP
MASK LED
BALLLIFT
BALL DETECTOR
HBR INPUTS
SPARE RELAYFOUL DETECTOR
BUMP RELAY
PITLIGHT
MOTOR DRIVE
INPUTS
PIN DETECTOR VDC +12
SPARE INPUTS
SWEEPBRAKE
TABLEBREAK
STACKLIGHT
MTR DRV SIG
PIN DETECTOR
REDLIGHT
COUNTER
PIT LIGHT
MOTOR DRIVE
INPUTS
PIN DETECTOR VDC + 12
SPAREINPUTS
SWEEPBRAKE
TABLE BREAK
STACKLIGHT
MTR DRV SIG
PIN DETECTOR
RED LIGHT
COUNTER
SCORING
MCU IN MCU OUT
DMX MTR DRV RS -485
TMS CONTROLLER
TMS CHASSIS
P/N: -2003-65EC
4 -2 ‘ ’ FROM HD COM CONNECTORY1
I/O ‘ ’TO YCOMCONTROLLER D4
CONNECTOR
COIN OP*
BILL ACCEPTOR*
TICKET DISPENSER
I/O CONTROLLER
*: Please refer to the HW66 installation manual for the
Coin Op and Bill Acceptor connection.
Connect the ground cable (green/yellow) coming from the 4HD-2COM unit
to the ground connection present on the 4HD-HUB support.
4 -HD HUB
POWER
To 4 -HD/5HD CPU To Odd SuperTouch To Even SuperTouch
To Scoring
Network switch
U
1
Y1 PS
Y1 Power Y1 PS Stat us
S1
4 -HD 2COM
P/N: -2003-64EC
4 -2 ‘ ’ FROM PSHD COM CONNECTOR
’TO SCORINGTMS CHASSIS ‘
CONNECTOR
The 4HD-HUB unit must
be installed under the
TMS chassis in the
support used for the
chassis and the 4HD-
2COM unit must be
installed under the 4HD-
HUB unit Please refer to
the Table T.90.251 for
the connections for the
4HD-2COM unit.