BES X installation manual BES X Dual Mode
P/N: 400288005; Rev: L, 09/21 123
15.4 How to install the card reader device on the console pedestal
15.4.1 How to replace the old table plate with the card reader plate on a pedestal
1. Make sure that the lane pair is completely turned off.
2. Open the cable cover located on the rear of the SuperTouch console, disconnect the LAN cable(s)
and remove it from the pedestal.
3. Remove the table from the original plate by unscrewing the four (4) retaining screws.
4. Remove the V-Support back (P/N: 286002852) by unscrewing the two (2) retaining screws.
5. Completely remove the two (2) rear retaining screws from the V-Support.
6. Loose the three (3) remaining retaining screws then slide the V-Support to remove it from the
pedestal.
To Next Page
Loading...