BES X Dual Mode BES X installation manual
126 P/N: 400288005; Rev: L, 09/21
4. Mount the card reader to the enclosure (P/N: 060060037). Connect the network cable and the 4-pin
cable to the card reader respecting the specified color sequence. Fix the card reader enclosure (P/N:
060060037) to the card reader plate using four (4) PHPMS M4-.7 X 8 ZN screws (P/N: 863040087).
5. (Re)Install the (EasyKey or SuperTouch) console(s) to the V-Support, connect the cable(s), close the
console’s cable cover and turn on the lane pair.
15.5 Software setup
Follow the procedure described in the section System first startup of this manual, but apply the following
modifications to the Lane Setup parameters (in Conqueror X):
15.5.1 Dual Mode Conqueror X Lane Setup
In this sub-section, we will only describe the parameters used for a correct setup of a Dual Mode installation.
Refer to the section Lane setup parameters screen brief description for further information.
Bowling type: select Highway 66.
Serial number: Insert here the serial number of the 4HD/5HD-CPU operating on this pair of lanes (or lane).
Keyboard: Select one of the following:
• SuperTouch console with English language en-us_TOUCH: Chinese touch screen,. Eastern Europe
touch screen, English touch screen, Korean touch screen, Vietnamese touch screen.
• Japanese touch screen (ja_TOUCH): SuperTouch console with Japanese language.
• German touch screen (de-de_TOUCH): SuperTouch console with German language.
• Russian touch screen (ru_TOUCH): SuperTouch console with Russian language.
Lane monitors: Specify the model of the overhead monitors connected to the serial control cable or IR control
cable to the 4HD/5HD-CPU. Select “QUBICA STANDARD” if the monitor is not supported.
Monitors on lanes: Always select “2 UP – 2 DOWN” (two overhead monitors and one SuperTouch console
per lane).
Redemption: Enables the Redemption.
Pinspotter type: this field cannot be modified and is preset to “QAMF TMS HW66 DIRECT COM”.
To Next Page
Loading...