BES X installation manual Replacements
P/N: 400288005; Rev: L, 09/21 127
16 Replacements
16.1 How to replace the 4HD/5HD-HUB unit
Turn off the faulty 4HD/5HD-HUB by unplugging the power cord from the 4HD/5HD-HUB unit itself;
Disconnect and remove the faulty 4HD/5HD-HUB unit from the wall support;
Position and connect the new 4HD/5HD-HUB in the same way as the old one.
Check that all the cables are connected;
Turn on the new 4HD/5HD-HUB.
16.2 How to replace the 4HD/5HD-CPU unit
Turn off the pair of lanes where the faulty 4HD/5HD-CPU is installed by unplugging the power cord from the
4HD/5HD-HUB unit.
Disconnect and remove the faulty 4HD/5HD-CPU;
Connect the new 4HD/5HD-CPU in the same way as the old one. Check that all the cables are connected;
Turn on the pair of lanes by plugging in the power cord to the 4HD/5HD-HUB unit;
Wait until the boot-up image is displayed on the lane monitors;
Read the serial number written on the lane monitors;
Enter Conqueror X with a user allowed to access the Lane Control Box Replacement;
Enter Conqueror X with a user allowed to access the Lane Control Box Replacement, navigate
through the main menu and select: SETUP / Lane Setup / Lane Control Box Replacement.
Insert the serial number, retrieved from the lane monitors,
inside the Lane Control Box Replacement window and, if
necessary, click on the Lanes Selected field.
To Next Page
Loading...