QubicaAMF 400288005 - How to Replace a Supertouch Console

BES X installation manual Conqueror Pro procedures
P/N: 400288005; Rev: L, 09/21 137
18.4 How to replace a SuperTouch console
Turn off the 4HD/5HD-HUB by unplugging the power cord from the 4HD/5HD-HUB unit to turn off the pair of
lanes where the faulty SuperTouch console is installed;
Disconnect and remove the faulty SuperTouch console from the pedestal;
Fix and connect the new SuperTouch console in the same way as the old one;
Check that all the cables are connected;
Turn on the new 4HD/5HD-HUB.
Wait until Test LCD R Error 199 or Test LCD L Error 199 appears on the overhead monitors, or when the lane
boots-up properly.
Navigate through the Conqueror Pro main menu and select: Setup / Technical Lane Setup / Upload to lanes.
Click on the Lanes selected box.
In the screen that appears, select ONLY the pair of lanes where the SuperTouch console has been replaced
and click OK.
On the Upload to Lanes screen click on Reinitialize.
Click on Yes when the Warning message appears.
The Reinitialize procedure will now start.
IMPORTANT: This procedure will take more than an hour to finish. DO NOT switch off the BES X system
during the Reinitialization process.
The system will reboot when the Reinitialization process has finished.