BES X installation manual BES X system configurations
P/N: 400288005; Rev: L, 09/21 15
3 BES X system configurations
IMPORTANT NOTE: Never, for any reason, run low voltage signal cables (such as network cables)
near any kind of high voltage source.
3.1 No console present
This is the simplest configuration. The following devices are installed on each pair of lanes:
• the camera (Q-Vision or T/M-Vision);
• the pinspotter interface;
• other optional LCOM devices (Bumper interface, Q-FOUL, TMR, etc.);
• one 4HD/5HD-HUB;
• one 4HD/5HD-CPU;
• the overhead monitors (i.e. two overhead monitors).
The camera, pinspotter interface and the other optional LCOM devices are connected to the 4HD/5HD-HUB
via the LCOM cable (Refer to section LCOM Line for further information).
The L1 port of the 4HD/5HD-CPU is connected to the L1 port of the 4HD/5HD-HUB via a network cable.
Each overhead monitor is connected to the corresponding port of the 4HD/5HD-CPU unit with a HDMI cable.
If the monitors do not support commands via the HDMI, a serial communication cable (P/N: 288401007)
must be installed between the overhead monitors and the 4HD/5HD-CPU in order to be controlled directly
from a Conqueror X computer.
To Next Page
Loading...