BES X installation manual BES X system configurations
P/N: 400288005; Rev: L, 09/21 23
3.3 SuperTouch console
3.3.1 Brief description
The SuperTouch is the touch screen console. It gives access to all of the on-lane functions of the BES X system.
The SuperTouch console is Intercom-ready. This fact does not mean that the Intercom system will be
automatically available on the lanes because the Intercom system must be purchased separately.
There are different versions for the SuperTouch console:
• SuperTouch console, P/N: 288150024;
• SuperTouch Ver. 2, P/N: 288150026 (from Conqueror Pro version 10.12.05 or higher);
• SuperTouch Rev. 3, P/N: 288150027 (from Conqueror Pro version 11.05.04 or higher);
• SuperTouch Rev. 4, P/N: 288150028 (from Conqueror Pro version 11.05.04 or higher);
• SuperTouch Rev. 4.1, P/N: 288150031 (from Conqueror Pro version 11.43.05 or higher, or Conqueror
Pro version 12.21.03 or higher);
• SuperTouch Rev. 5, P/N: 288150029 (from Conqueror Pro version 13.00.00 or higher);
The main difference between the SuperTouch console (P/N 288150024) and the newer versions is that the
first generation SuperTouch console (P/N: 288150024) needs to be connected to the 4HD/5HD-HUB unit
using two network cables, while the newer versions needs to be connected to the 4HD/5HD-HUB unit using
one network cable.
288150031 SuperTouch consoles that have a serial number starting with “5”, e.g. “50136”, are equipped with
a different generation of touchscreen.
It is possible to install different versions of SuperTouch consoles together in the same installation. Please
refer to the drawings below for further information.
3.3.2 Exposure of the SuperTouch console to ultraviolet (UV) rays
The principal recommendation is to AVOID the SuperTouch console being exposed to ultraviolet rays.
Following this recommendation:
• Do NOT expose the SuperTouch console to direct sunlight.
• NEVER install, for any reason, a SuperTouch console near a window or in a position where it will be
exposed to direct sunlight.
• In the case of Wood lamps (UV lamps):
o MINIMUM distance allowed: 3 mt (10’). NEVER install, for any reason, a SuperTouch console
within a range of 3 mt from a Wood lamp (UV lamp).
o RECOMMENDED minimum distance: 6 mt. (20’).
o If a Wood lamp (UV lamp) is installed within the range of 3 mt. (10’) and 6 mt. (20’), the
usage of the lamp must not exceed 20 hours per week.
Failing to follow these recommendations will cause permanent damage to the SuperTouch console.
To Next Page
Loading...