Scoring network BES X installation manual
68 P/N: 400288005; Rev: L, 09/21
T.40.012 – Cat.5e Wall Mounting Box standard network cable
THIS DRAWING IS INDICATIVE.
ALWAYS check the color sequence on the instructions attached to the wall
mounting box for T568B wiring
• Strip approximately 30mm of the cable jacket and separate into 4 pairs.
• Follow the direction on the IDC color-coding to position T568B wiring
and insert the wires into each slot.
• Use the impact tool to crimp and connect the wires.
• Hold tightly with cable jacket by cable tie to avoid the cable falling off or
pulling away.
• Fix the Cat.5 Wall Mounting Box to the wall.
T.40.008 – Standard Network Cables
1 2 3 4 5 6 7 8
Orange / White
Orange
Blue
Blue / White
Green
Brown / White
Brown
Green / White
1 2 3 4 5 6 7 8
Orange / White
Orange
Blue
Blue / White
Green
Brown / White
Brown
Green / White
1 8
Plug 1
1 8
Plug 2
Category 5
Unshielded
CableUTP
Protection
Cap
RJ45 Plug
Pin1
Pin8
13 mm
1/2"
• Skin off the cable jacket approximately 25mm (1").
• Untwist each pair and straighten the wires.
• Put the protection caps on the cable
• Place the wires in the right order. For a Standard cable wire both ends as Plug 1.
• Cut all the wires at a perfect 90 degrees angle, at 13mm (1/2") from the cable jacket.
• Insert the wires into the plug.
• Crimp the plug.
To Next Page
Loading...