QubicaAMF 400288005 - How to Enable the Just Scan (or Screen Fit) and HDMI-CEC Capabilities on Monitors Supplied by Qubicaamf

Overhead monitors BES X installation manual
74 P/N: 400288005; Rev: L, 09/21
7.3 How to enable the “Just Scan” (or “Screen Fit”) and “HDMI-CEC”
capabilities on monitors supplied by QubicaAMF
When using monitors supplied by QubicaAMF, follow one of the procedures listed below that depend on the
brand / model of the monitors, in order to enable the “Just Scan” (or “Screen Fit”) capability.
ACCUVISION MONITORS Gen.3 and Gen.4:
How to enable the control “HDMI-CEC”:
• Enter the main menu of the monitor by pressing once the “Menu” button on the remote control.
• Once the main menu screen has appeared on the monitor, press in a fast sequence the following
buttons on the remote control: “Menu”, “9”, “6”, “3”, “2”.
• Navigate to the “TV Control” setting and press “OK” on the remote control.
• Set the control “HDMI-CEC” (this setting lets the control commands to be executed through the HDMI
cable).
• Once finished, press many times the “Menu” button on the remote control to exit from the menu.
ACCUVISION MONITORS Gen.2, Gen.3 and Gen.4:
How to enable the “JUST SCAN” option:
If the image displayed on the monitor is larger than the monitor screen, follow this procedure in order to
have a correct aspect ratio:
• Press once the “Menu” button on the remote control.
• Enter the main menu of the monitor by pressing once the “Menu” button on the remote control.
• Once the main menu screen has appeared on the monitor, press in a fast sequence the following
buttons on the remote control: “Menu”, “9”, “6”, “3”, “2”.
• Navigate to the sub menu “Aspect Ratio”.
• Select “Just Scan” and press “OK” on the remote control.
• Once finished, press many times the “Menu” button on the remote control to exit from the menu.
SAMSUNG MX SERIES MONITORS:
How to enable the “JUST SCAN” (or “Screen Fit”) option:
If the image displayed on the monitor is larger than the monitor screen, follow this procedure in order to
have a correct aspect ratio:
• Enter the main menu of the monitor by pressing once the “Menu” ( ) button on the remote
control.
• Navigate to the “Picture” menu, using the arrow buttons and press the “Enter” ( ) button on the
remote control.
• Navigate to the “Size” sub menu and press the “Enter” ( ) button on the remote control.
• Select the “Just Scan” (or “Screen Fit”) option and press the “Enter” ( ) button on the remote
control.
• Once finished, press many times the “Exit” ( ) button on the remote control to exit from the menu.