BES X installation manual Front Desk
P/N: 400288005; Rev: L, 09/21 83
9.3 Lanes Control Box Service
The Lanes Control Box Service (also called the Matrix Configuration service or MxServer) is the program that
manages the allocation of IP addresses to the 4HD/5HD-CPU units each time they boot-up.
To setup the lane control box service you must open the SYSTEM tab under the icon SETUP /
General / Center Setup in Conqueror X.
Insert the IP address of the Conqueror Server computer where the Lanes Control Box Service is installed into
the BES server IP address field. The IP should be 192.168.71.1 (in the case of a front desk computer that acts
as the Server) or 192.168.71.99 (in the case of a Separate Server).
Insert the IP address of the second network card of the Conqueror X computer where the Lanes Control Box
Service is installed into the BES lane subnet address field. The IP should always be 192.168.216.1.
WARNING: You can have only one Lanes Control Box Service running per Bowling Center.
If these two IP addresses are not set, then Conqueror will display an error each time the system boots-up.
In order to apply any change on this screen press SAVE and Conqueror X will restart.
To Next Page
Loading...