QubicaAMF 90XLi PINSPOTTER
400-088-012 Page 2-4 Rev. Date 11/06
2.2.2 Vise Lacer Instructions
The clipper belt lacer is provided to help the center mechanic manufacture replacement
distributor belts. The optimum belt length can vary slightly from distributor to distributor. If
possible, match the existing belt length. The belt lacing will add approximately 1/4 inch to
the overall, installed belt length. One end of the belt should have lacing containing an odd
number of individual hooks while the other end should have lacing with an even number of
hooks (see Figure 2-7b). To make a belt, proceed as follows:
1. Cut a section of belt
material to the
appropriate length
(approximately 116¼ -
116½ inches). The
approximate finished
belt length is from 116½
116¾ inches.
2. Place the open clipper
belt lacer (Figure 2-6a)
between the jaws of a
vise. Remove the guide
pin from the hole in the
end of the lacer, if
installed.
3. Place card of hooks in
retainer. Insert lacer pin
and remove carding
paper.
4. Insert belt between hook
points. For optimal
splice, it is recommended
to have the bottom side
of belt facing the
pressure plate.
5. Close vise as tightly as
possible, then release.
6. When complete, remove
the lacer pin, and lift the
belt out of the lacer.
NOTE: If the belt is wider than
the vise jaws, perform the
following steps:
A. Align belt and lacer with
edge of vise jaw.
B. Complete lacing step 5.
C. Slide tool so next section
of the lacer is in contact
with the vise jaws and
complete step 5 again.
D. Finish with step 6.
Figure 2-6a
Figure 2-6b
Figure 2-6c
Figure 2-6d
To Next Page
Loading...