SECTION 4.0
Troubleshooting
400-088-012 Page 4-1 Rev. Date 11/06
4.0 TROUBLESHOOTING
4.1 PROBLEM: Distributor does not feed pins at correct bin position.
Check bump on nylon gear with
beveled tooth on pinion gear.
Align if necessary. Make sure
Distributor is in the #1 bin
position when aligning.
START
Distributor drive cam
not indexed with
pinion gear?
Distributor not
centered properly?
Run distributor to #1 bin
position and center by
adjusting the safety link.
NO
YES
YES
To Next Page
Loading...