BES X Installation Manual, Rev.9, Jun 2018 System boot up sequence
P/N: 400288005 137
Consoles:
Error 151 One EasyKey console has been installed with the 286-002-819 speaker cable, while the
other EasyKey console has been installed with the 286-002-824 speaker cable.
Error 190 No communication with the Console (3)
Error 191 Console program check Fail (4)
Error 192 Console program check Fail (4)
Error 193 Console program check Fail (4)
Error 194 Console program check Fail (4)
Error 195 Console program check Fail (4)
Error 196 Console program check Fail (4)
Error 197 Console program check Fail (4)
Error 198 Console program check Fail (4)
Error 199 Console detected but not entering in Run mode (5)
Test TV / Q-Vis / Q-All Error Number:
Error 200 No communication with the master LCOM device (6)
Error 200/1 Unexpected communication character (6)
Error 200/2 Wrong character communicating with the master LCOM device (6)
Error 200/3 The master LCOM device seems okay (6)
Error 200/4 Six seems okay (6)
Error 200/5 Six communication fail (6)
Error 201 Wrong char on master LCOM device Bin file (6)
Error 202 Master LCOM device communication failure (6)
Error 203 Camera Fail Check. If there is a camera on each lane, the problem is with the camera of the
Left lane (7)
Error 204 Check Camera Lane Right Fail (7)
Error 205 Master LCOM device communication failure (6)
Error 205/XX Master LCOM device may not be properly programmed (6)
Error 206 Wrong header on master LCOM device Bin file (6)
Error 208 Impossible to communicate with F-Box (8)
Error 209 Old F-Box version (Version 1.0) (9)
Error 210 T-Vision hardware not compatible (10)
Error 211 F-Box strike time not valid (11)
To Next Page
Loading...