Electrical specifications BES X Installation Manual, Rev.9, Jun 2018
26
26 P/N: 400288005
Provide AC power to the system components via an electrical subpanel that is dedicated solely to the BES X
system. The subpanel must have a neutral bus and a separate insulated third-wire isolated ground that is
connected at the main service panel only.
Provide AC power to other system components as described with each component, including installing
distribution boxes and running power cables to the final location of the other system components.
Test the electrical ground before installing any components and periodically thereafter it to ensure the BES
X system remains properly grounded.
IMPORTANT: Only QubicaAMF-supplied devices should be plugged into the outlets dedicated for
QubicaAMF components.
ALWAYS FOLLOW YOUR LOCAL CODES FOR WIRE STANDARDS AND WIRING CIRCUIT.
PLEASE REFER TO THE “BES X PRE-INSTALLATION MANUAL” FOR FURTHER AND DETAILED INFORMATION.
To Next Page
Loading...