QubicaAMF BES X - Supertouch Lane Console

BES X system configurations BES X Installation Manual, Rev.9, Jun 2018
38
38 P/N: 400288005
3.7 - SuperTouch Lane console
In this configuration on each pair of lanes there will be installed:
 the camera (Q-Vision or T/M-Vision);
 the pinspotter interface;
 other optional LCOM devices (Bumper interface, Q-FOUL, TMR, etc…);
 one 4HD/5HD-HUB;
 one 4HD/5HD-CPU;
 the overhead monitors (i.e.: two overhead monitors);
 two SuperTouch console.
The camera, the pinspotter interface and the other optional LCOM devices are connected to the 4HD/5HD-
HUB via the LCOM cable (Refer to section “6 – LCOM Line” for further information).
The L1 port of the 4HD/5HD-CPU is connected to the L1 port of the 4HD/5HD-HUB via a network cable.
Each overhead monitor is connected to the proper port of the 4HD/5HD-CPU unit with a HDMI cable. If the
monitors does not support commands by the HDMI, a serial communication cable (P/N: 288401007) has to
be installed between the overhead monitor and the 4HD/5HD-CPU in order to be controlled directly from a
ConquerorPRO computer.
The SuperTouch Ver.2 (PN: 288150026) on the odd lane is connected to:
 L3 port of the 4HD/5HD-HUB through a network cable (grey cable);
The SuperTouch Ver.2 (PN: 288150026) on the even lane is connected to:
 L4 port of the 4HD/5HD-HUB through a network cable (yellow cable);
Or
The SuperTouch console (PN: 288150024) on the odd lane is connected to:
 L3 port of the 4HD-HUB through a network cable (grey cable);
 P1 port of the 4HD-HUB through a network cable (red cable): connect the network cable on the
4HD-HUB side to the 288401035 cable adapter then the 288401035 cable adapter to the P1
connector of the 4HD-HUB unit.
The SuperTouch console (PN: 288150024) on the even lane is connected to:
 L4 port of the 4HD-HUB through a network cable (yellow cable);
 P1 port of the 4HD-HUB through a network cable (blue cable): connect the network cable on the
4HD-HUB side to the 288401035 cable adapter then the 288401035 cable adapter to the P1
connector of the 4HD-HUB unit.
Each console has to be connected to ground. Please refer to the section “5 – Suggested ground
connection” of the BES X – PRE-Installation Manual for further information.