T. 0.4 012
MAY 2nd 1720
CAT.5e WALL MOUNTING
BOX STANDARD
NETWORK CABLE
- Strip approximately 30mm of the cable jacket,and separate to 4
pair each.
- Follow the direction on the color-coding to positionIDC
T568B wiring, separate a little space on proper position
and insert the wire pair by pair into each slot.
- Use the impact tool to crimp and connect the wires.
- Hold tightly with cable jacket by cable tie to avoid the cable falling
off or pulling away.
- Fix the Cat.5 Wall Mounting Box to the wall.
1
2
5
4
6
7
8
3
CABLE TIE
THIS DRAWING IS INDICATIVE.
ALWAYS CHECK THE COLOR SEQUENCE ON THE
INSTRUCTIONS ATTACCHED TO THE WALL
MOUNTING BOX FOR T568B WIRING.
To Next Page
Loading...