QubicaAMF XLi EDGE Series - Page 99

Critical Measurements
Section 4-2 4.2-40 Rev. Date: 10/2016
Back End height vs. Front End height at connection points .................................................................................................................................................................
Approximately Even
PBL
Lift arm height above door weldment ..................................................................................................................................................................................................
1
/
8
” to
3
/
16
” (3–5 mm) above weldment
PBL height (clearance between ball on lift arm and lift belt) ...............................................................................................................................................................
5
/
16
”–
3
/
8
” (8–9.5 mm)
LBS
Distance LBS should travel after rudder hits bumper ..........................................................................................................................................................................
1
/
16
” –
1
/
8
” (1.5–3 mm)
Gap between Trip Cam and followers (L&R) with rudder centered ....................................................................................................................................................
1
/
8
” (3 mm)
Distributor
Distributor Spacer 070-006-143 ............................................................................................................................................................................................................
Used on Distributor Post
Distributor Mount .................................................................................................................................................................................................................................
One side must contact Rear Dist. Crossbeam Support
Distance between trip arms ..................................................................................................................................................................................................................
3” (76 mm) Max
learance between belt guard and screw head on bin ..........................................................................................................................................................................
1
/
8
”– ¼” (3–6 mm)
Sweep
Length of each long rod.........................................................................................................................................................................................................................
10 threads showing (total of both ends); 12 on 7-pin side
Distance above pin deck at 1
st
Guard ...................................................................................................................................................................................................
1
1
/
8
” ±
1
/
8
” (1”– 1¼”: 25–32 mm)
Distance above pin deck at the center of the #4, #5, & #6 Spots .........................................................................................................................................................
3
/
16
”±
1
/
16
” (
1
/
8
”–
1
/
4
”: 3–6 mm)
Maximum rearward travel (manually cranked) ...................................................................................................................................................................................
Front of bar at back of 7 -10 row
Ball Detector
–WHEN MOUNTED OUTSIDE THE PATH OF THE SWEEP–
Distance from center of detector/reflector to the 7–10 Line ..............................................................................................................................................................
59¾” ± ½” (59¼”– 60¼”: 1505–1530 mm)
Height of detector mounting platform above Pin Deck .......................................................................................................................................................................
Capping height +
5
/
16
” (8 mm)
–WHEN MOUNTED INSIDE THE PATH OF THE SWEEP (NOT RECOMMENDED)–
Distance from center of detector/reflector to the 7–10 Line ..............................................................................................................................................................
51½” ± 1” (50½”– 52½”: 1283–1334 mm)
Thickness of board used to mount detector to nose of kickback ........................................................................................................................................................
1
/
4
”–
3
/
8
” (6–9.5 mm)
Approximately Even
6½” (165 mm)
Spacer Washers
7-10 Line
Trip Cam
Follower
1/8” (3 mm)
Trip Cam
1/8” (3 mm)
5/16” to
3/8”
(8–9.5 mm)
Clearance