QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038 33 Revision F
3.3.8 Oil Filling
The oil used in the back end gearbox is a life-long lubricant. It only needs to be changed when an oil seal(s) is
replaced. The amount of oil needed for each back end gearbox is 44.8 ounces.
Tools Required
Klüber Oil (P/N 715-022-505/516) Funnel
Measuring Container 17mm Wrench (P/N 793-506-011)
1. Continued from Section 3.3.3 – Oil Draining.
2. Measure out 44.8 ounces of Klüber oil.
3. Pour oil into gearbox, using a funnel, through the hole where the vent plug was until the oil level
reaches the red dot of the sight glass.
4. Place plug washer onto the threaded opening in the top of the body.
5. Screw the vent plug into the threaded opening.
6. Tighten the vent plug with a 17mm open wrench to 90 in-lbs.
7. Reinstall the gearbox in the pinspotter and the motor to the gearbox. Install the drive belts and
distributor drive shaft, and reconnect the gearbox motor’s electrical connector.
8. If maintenance is complete, return the pinspotter to service.
Caution! Oily rags can be a fire hazard. Dispose of them in an approved metal container only!
To Next Page
Loading...